Wireless 2.4GHz Auto-Gain Booster

  • The outdoor solution—a bi-directional Amplifier is designed for 2.4GHz wireless LAN. It comes with an easy plug-and-play installation, which works together with an indoor Wireless Access Point to improve its operation range and performance. The unit is ideal to use with 2.4GHz Frequency Hopping, Direct Sequence Spread Spectrum radio modems and 11Mbps IEEE 802.11b devices. The amplifiers increases range by providing transmit gain as well as low-noise receive gain. This receive gain increases the receive sensitivity of wireless LAN Access Point.


    • Max. broadband and distance in wireless communication
    • High gain, high value and high performance
    • Support point to point connectivity for long distance without the use of cables
    • Reduce ambient noise and provide superior signal strength
    • Lightning protection

  • Operating Range

    • 2400~2500 MHz

    Operating Mode

    • Bi-directional, half-duplex, auto-switching via carrier sensing

    Connector Type

    • N-type, female (50 ohm)

    Transmit Gain

    • 18dB

    Tx Input Power

    • 0 ~15 dBm

    Output Power

    • 1W (30 dBm)

    Receiver Gain

    • 15 dB

    Noise Figure

    • 3.5dB

    Frequency Response

    • ± 1 dB over operating range

    Power Adaptor

    • 7~9V /DC 110/220V /AC auto switching AC Adapter for DC Injector

    Operating Temp.

    • -20 to +70℃

    Operating Humidity

    • Up to 95% relative humidity


    • Cast Aluminum

    Lightning Protection

    • Direct DC ground at antenna connector

    DC Surge Protection

    • At DC input from transmission cable

    Outdoor Unit (cm)

    • 11.5cm(L) x 6.5cm(W) x 4.8cm(H)

    DC Injector (cm)

    • 10.2cm(L) x 3.6cm(W) x 2.6cm(H)


    • 345g (Booster) / 96g (DC Injector)

  • RP-WR1201G  Wireless 2.4GHz Auto-Gain 1W Booster
    RP-WR1201G/40 Wireless 2.4GHz Auto-Gain 4W Booster

Related Products